BSWVG - 80 951 TUNGSEAL LIMED OAK
- MSDS: BSWVG
- Manufacturer: VALSPAR CORP
- Product Name: 80 951 TUNGSEAL LIMED OAK
- National Stock Number: 8010-00N047984
Product Identification
Product ID:80 951 TUNGSEAL LIMED OAK
MSDS Date:10/26/1989
FSC:8010
NIIN:00N047984
MSDS Number: BSWVG
Responsible Party
MINNEAPOLIS, MN 55415
US
Emergency Phone: 800-228-5635
Info Phone: 612-332-7371
Cage: 13418
Contractor
Telephone: 612-332-7371/800-228-5635
Cage: 13418
Ingredients
STODDARD SOLVENT; (EXEMPT MINERAL SPIRITS)
CAS: 8052-41-3
RTECS: WJ8925000
Fraction By Weight: 70%
OSHA PEL 500 PPM
ACGIH TLV: 100 PPM
TITANIUM OXIDE; (TITANIUM DIOXIDE)
CAS: 13463-67-7
RTECS: XR2275000
Fraction By Weight: 15%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:HARMFUL IF INHALED. MAY AFFECT
BRAIN, NERVOUS SYSTEM OR RESPIRATORY SYSTEM, CAUSING DIZZINESS,
HEADACHE, NAUSEA OR RESPIRATORY IRRITATON. PROLONGED INHALATION OF
DUSTS MAY RESULT IN SHORTNESS OF BREATH. OVEREXPOSURE TO INGS IN
THIS PRODUCT MAY CAUSE NOSE & THROAT IRRITATION, EYE/SKIN
IRRITATION. (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:CHRONIC:NOTICE:REPORTS HAVE ASSOCIATED
REPEATED & PROLONGED OCCUPATIONAL OVEREXPOSURE TO SOLVENTS
W/PERMANENT BRAIN & NERVOUS SYSTEM DAMAGE. INTENTIONAL MISUSE BY
DELIBERATELY CONCENTRATING & INHALING CONTENTS MAY BE HARMFUL OR
FATAL.
Medical Cond Aggravated by Exposure:ANY RESPIRATORY OR SKIN CONDITION.
First Aid
First Aid:EYE:FLUSH IMMEDIATELY W/PLENTY OF WATER FOR AT LEAST 15
MINUTES & GET MEDICAL ATTENTION. SKIN:WASH THOROUGHLY W/SOAP &
WATER. INHAL:REMOVE TO FRESH AIR. INGEST:GET MEDICAL ATTENTION
IMMEDIATELY.
Fire Fighting
Flash Point Method:TCC
Flash Point:106F,41C
Lower Limits:1%
Upper Limits:7%
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, FOAM &/OR WATER FOG.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT . CONTAINERS EXPOSED TO FIRE SHOULD BE KEPT COOL W/WATER
SPRAY.
Unusual Fire/Explosion Hazard:CONTAINS OXIDIZING MATLS. CONTAM RAGS,
WIPES, SAWDUST, ETC MAY CATCH FIRE SPONT. STORE WASTE UNDER WATER
IN CLSD METAL CNTNRS UNTIL DISP OF IN (SUPP DATA)
Accidental Release
Spill Release Procedures:VENTILATE AREA. AVOID BREATHING OF VAPORS. USE
NIOSH/MSHA APPROVED SCBA OR AIRMASK FOR LARGE SPILLS IN A CONFINED
AREA. AVOID CONTACT W/EYES.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:KEEP AWAY FROM HEAT, SPKS & OPEN
FLAMES. KEEP CNTNR CLSD WHEN NOT IN USE. DO NOT STORE >120F.
Other Precautions:BASED ON PROD FLASH POINT & VAP PRESS SUITABLE STOR
SHOULD BE PROVIDED I/A/W OSHA REG 1910.106. EMPTY CNTNRS MAY
CONTAIN PROD RESIDUE, INCL FLAMM/EXPLO VAPS. DO NOT CUT,
PUNCTURE/WELD ON/NEAR CNTNR. A LL LBL WARNINGS MUST BE
OBSERVED(SUPDAT)
Exposure Controls
Respiratory Protection:WEAR APPROPRIATE, PROPERLY FITTED NIOSH/MSHA
APPROVED RESPIRATOR DURING & AFTER APPLICATION UNLESS AIR
MONITORING VAPOR/MIST LEVELS ARE BELOW APPLICABLE LIMITS. FOLLOW
RESPIRATOR MFR'S DIRECTIONS FOR RESPIRATOR USE.
Ventilation:REQUIRED FOR SPRAYING OR IN A CONFINED AREA, VENTILATION
EQUIPMENT SHOULD BE EXPLOSION PROOF.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPROVED CHEM WORK GOGGLES .
Other Protective Equipment:USUAL CLOTHING FOR PAINTING OPERATIONS.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EXPLO HAZ:COMPLIANCE W/ALL APPLICABLE REGULATIONS. OTHER PREC:UNTIL THE
CONTAINER HAS BEEN CLEANED OR RECONDITIONED.
Chemical Properties
Boiling Pt:B.P. Text:319F,159C
Vapor Pres:2 @ 100F
Vapor Density:4.8
Spec Gravity:0.92
Evaporation Rate & Reference:0.1 (BUTYL ACETATE=1)
Solubility in Water:NO
Appearance and Odor:NORMAL FOR A COATINGS PRODUCT.
Percent Volatiles by Volume:85.27
Stability
Stability Indicator/Materials to Avoid:YES
Stability Condition to Avoid:NONE
Hazardous Decomposition Products:CARBON DIOXIDE/MONOXIDE, METAL OXIDES.
Disposal
Waste Disposal Methods:DISPOSE IN CHEMICAL DISPOSAL AREA OR IN A MANNER
THAT COMPLIES W/LOCAL, STATE & FEDERAL REGULATIONS. DO NOT
INCINERATE CLOSED CONTAINERS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.